Van essentials

Understanding van payload

Maximum authorised mass, kerb weight and mass in service explained, plus what happens if you overload.

By Bilal Javed Published 4 min read

A van's payload is the maximum weight of people, equipment and cargo it can carry, worked out as its maximum authorised mass minus its own kerb weight. The number in the brochure is usually the best case. Once you subtract the driver, passengers, racking and tools, the weight you can actually load can be a couple of hundred kilograms lower.

The weights you need to know

TermWhat it meansWhere to find it
Maximum authorised mass (MAM)The most the van may weigh on the road, fully loaded. Also called gross vehicle weight.VIN plate; V5C box F.1
Kerb weightThe empty van with fluids and fuel, ready to drive, usually without a driverManufacturer specifications
Mass in serviceSimilar to kerb weight, but by definition includes a 75 kg driver allowanceV5C box G
Axle limitsThe most each axle may carryVIN plate
Gross train weightThe most the van plus a trailer may weighVIN plate

GOV.UK's page on vehicle weights explains these terms officially. The key point is that MAM is a legal limit, not a target.

Gross payload versus usable payload

Gross payload is simply MAM minus kerb weight. If a 3,500 kg van has a 2,200 kg kerb weight, its gross payload is 1,300 kg.

Usable payload is what is left for cargo once everything else on board is counted:

  • the driver, and any passengers;
  • racking, shelving, ply lining and roof racks or ladders;
  • tools, spares and equipment that live in the van;
  • extra fuel cans, water tanks or AdBlue;
  • options fitted after the brochure figure was measured, such as a tow bar or a bulkhead.

Take the 1,300 kg example. Two people at 85 kg, 120 kg of racking and tools, and a 10 kg roof bar set bring usable payload down to about 1,000 kg. That is a 23% drop before any cargo goes in. Our Van Payload Calculator does this sum for you.

Kerb weight or mass in service?

If you take your figure from the V5C, it is mass in service, and under the definition used for type approval that already includes 75 kg for the driver. Count the driver again and you will underestimate the payload by 75 kg. If your figure is a brochure kerb weight, it normally excludes the driver. When in doubt, assume the driver is not included. You will get a slightly cautious answer, which is the safe side to err on.

Axle limits

A van can be under its MAM and still illegal, because one axle is overloaded. The front and rear axle limits on the VIN plate usually add up to more than the MAM, which is normal: it allows some flexibility in where weight sits, not extra total weight.

The rear axle is the one at risk. A heavy load stacked at the back doors, or a tow bar with a loaded trailer, puts most of the weight behind or over the rear wheels. Load heavy items against the bulkhead and low down, and the weight spreads more evenly between the axles. A public weighbridge can weigh each axle separately if you need to check.

Licence limits

According to GOV.UK, a category B licence (the standard car licence for anyone who passed from 1 January 1997) covers vehicles up to 3,500 kg MAM for petrol and diesel vehicles, including hybrids. Zero-emission electric or hydrogen vans can be driven on category B up to 4,250 kg. Drivers who passed before 1997 usually also have C1, which covers vehicles between 3,500 kg and 7,500 kg. Check your licence for the categories shown, because the payload calculation is pointless if you are not licensed for the van in the first place.

What happens if you overload a van

Overloading makes a van brake later, corner worse and wear its tyres faster, and an overloaded tyre can fail. DVSA and the police weigh vans at the roadside. DVSA figures reported by Fleet News give these graduated fixed penalty bands for being over the weight limit:

Percentage overweightTypical outcome
5–9.99%£100 fixed penalty
10–14.99%£200 fixed penalty
15–29.99%£300 fixed penalty
30% or moreCourt summons

On top of any fine, the van can be prohibited from moving until the excess weight is taken off. Insurers may also refuse a claim if an overloaded vehicle is involved in a crash. Penalty amounts can change, so treat these as a guide and check current DVSA information.

How to avoid overloading

  1. Find your MAM and kerb weight or mass in service before you load.
  2. Estimate cargo weight honestly. Product sheets, delivery notes and supplier websites list weights for building materials and appliances.
  3. Run the numbers in the payload calculator, including people and fitted kit.
  4. If you are within about 5% of the limit, weigh the loaded van at a public weighbridge.
  5. Split the job into two trips or use a heavier-rated vehicle if you are over.

Frequently asked questions

What is a van's payload?

The weight you can add to the van on top of its own weight without going over its maximum authorised mass. Driver, passengers, equipment and cargo all come out of it.

Where can I find my van's weights?

On the VIN plate, usually on the driver's door pillar or under the bonnet, and on the V5C logbook: box F.1 for maximum permissible mass and box G for mass in service.

Is gross vehicle weight the same as MAM?

Yes. Gross vehicle weight, maximum authorised mass and maximum permissible mass are used to mean the same limit.

Can I drive a 3.5 tonne van on a car licence?

If you hold a full category B licence, yes, up to 3,500 kg MAM. Zero-emission vans up to 4,250 kg are also covered under GOV.UK rules.

Sources and further reading

About this guideWritten for LoadFit by Bilal Javed. We check facts against official sources such as GOV.UK and DVSA where rules are involved, and we update guides when those rules change. If something here is out of date or unclear, please let us know.