As a rough guide, a medium panel van takes two or three pallets, a long-wheelbase van three or four, and a Luton box van six or more, but the real answer depends on two measurements: the floor length and the width between the wheel arches. Pallet size matters too. A Euro pallet is 1200 × 800 mm and a UK standard pallet is 1200 × 1000 mm, and that 200 mm difference often decides whether pallets can go in sideways.
Common pallet sizes in the UK
| Pallet | Footprint (mm) | Notes |
|---|---|---|
| UK standard (ISO 2, also EUR 2) | 1200 × 1000 | The usual size in UK pallet networks |
| Euro pallet (EUR 1 / EPAL) | 1200 × 800 | 144 mm tall, about 25 kg empty |
| Half Euro (EUR 6) | 800 × 600 | Retail and smaller consignments |
| Quarter Euro | 600 × 400 | Display pallets |
The pallet's own height, 144 mm for a Euro pallet, counts toward the load height. A pallet of goods stacked to 1 metre is really about 1.15 metres tall.
Why the wheel arches decide the answer
Pallets sit on the floor, and on a panel van the floor is narrowest between the wheel arches. A van whose brochure says 1.75 m load width may have only around 1.35 m between the arches. That number, not the overall width, is the one to compare with your pallets.
Compare the arch width with both sides of the pallet:
- If it is wider than the pallet's long side (1200 mm), pallets can go in sideways, using 800 or 1000 mm of length each. That usually fits more.
- If it is only wider than the short side, pallets must go lengthways, using 1200 mm of length each.
- If it is narrower than the short side, the pallet will not sit flat on the floor at all.
The rear door opening has the same effect. The pallet has to travel through it with the same side across the van as it will sit on the floor, because turning a loaded pallet inside a van is rarely practical.
Worked examples
These use the illustrative vans in our Pallet Fit Calculator. The first figure allows a 2 cm gap between pallets, the second assumes they are pushed tight together. Real vans differ, so measure yours.
| Example van | Floor length × width between arches | Euro pallets | UK pallets |
|---|---|---|---|
| Medium (SWB) | 240 × 125 cm | 2, or 3 pushed tight | 2 |
| Large (LWB, high roof) | 330 × 135 cm | 4 | 3 |
| Luton box van | 400 × 200 cm | 6, or 8 pushed tight | 3, or 6 pushed tight |
Look at the medium van. Three Euro pallets sideways need 2.44 m with gaps, and the floor is 2.40 m. Push them tight together and three go in. The Luton shows the same effect more dramatically: two UK pallets side by side need exactly 2 metres, so a 2 m wide box floor takes six pushed tight but only three if you leave a gap between each pair. A few centimetres of floor width can halve or double the count, which is why measuring your own van matters so much.
Height and stacking
Check the loaded pallet height against both the rear door opening and the internal height. High-roof vans often have a door around 1.7 m tall, while a standard roof might be nearer 1.3 m. Double-stacking only works if both pallets together fit under the roof, the goods on the bottom pallet can take the weight, and the total stays inside payload. In practice, double-stacking in a van is uncommon for anything except light goods.
Payload: the limit people forget
Floor space is often not the real constraint. A pallet of tiles, bagged cement or bottled drinks can weigh several hundred kilograms, sometimes over a tonne. Many large panel vans have a usable payload in the region of a tonne once a driver is on board. So a van with room for four pallets may only be allowed to carry two heavy ones.
Work out the weight with the van payload calculator before you book, and remember that axle limits apply as well as the overall maximum. Keep the heaviest pallets forward.
Loading and securing pallets
- Use a tail lift, a loading bay or a forklift. Pallet trucks work well on a level van floor once the pallet is inside.
- Push the first pallet hard against the bulkhead. Gaps let the load move under braking.
- Strap every pallet to the floor tie-down points with ratchet straps. Shrink-wrap holds goods to the pallet, not the pallet to the van.
- Fill gaps with empty pallets or dunnage so the load cannot slide.
- Check the straps after the first few miles.
DVSA's code of practice on securing loads explains the principles in detail and applies to vans as well as HGVs.
Frequently asked questions
How many Euro pallets fit in a Luton van?
Often six to eight, depending on the body length and internal width. Box bodies have no wheel arches intruding, so the full floor width is usable, and a body around 2 metres wide can take Euro pallets two abreast.
Will a UK pallet fit in a medium van?
Often only one or two. A UK standard pallet is 1200 × 1000 mm, so it needs at least 1 metre between the wheel arches and a door opening wider than that.
What is the weight limit for a pallet in a van?
The limit is the van's payload, not the pallet. A loaded pallet can weigh more than a tonne, which is more than many vans can legally carry.
Do I need a tail lift for pallets?
For anything heavy, yes, or a loading bay with a forklift. Lifting a loaded pallet by hand is unsafe.